Приложение 2. Результаты выполнения некоторых команд через telnet

автор: Алексей Гречанинов

D-link Corp. Access Point wlan1 -> get config

wlan1 revisions: mac 5.8 phy 4.4 analog 4.6

PCI Vendor ID: 0x168c, Device ID: 0x13

Sub Vendor ID: 0x168c, Sub Device ID: 0x13

chip is AR2312

Country Code: GB

Operation Mode: Access Point

Wlan State: Enabled

Radio Frequency: 2457 MHz (IEEE 10)

Wireless LAN Mode: 802.11g

Auto Channel Select: Enabled

Extended Channel Mode: Enabled

Data Rate: best

Antenna: best

Login Username: admin

RADIUS address:

Name server IP address: 0.0.0.0

Name server domain suffix:

SSID: DWL2100AP

SSID Suppress Mode: Disabled

System Name: D-link Corp. Access Point

Beacon Interval: 100

DTIM: 1

Fragmentation Threshold: 2346

RTS/CTS Threshold: 2346

Short Preamble: Disabled

11g Only Allowed: Disabled

CTS Mode: AUTO

CTS Rate: 11 Mbps

CTS Type: CTS-ONLY

11g Overlapping BSS Protection: Enabled

11g Beacon Rate: 1 Mbps

11g Draft 5.0 compatibility: Disabled

Short Slot Time: Enabled

Basic 11g Rate Set: (1, 2, 5.5, 11)

11g Optimization Level: 1

Burst Time: 2

Burst Sequence Threshold: 3

IP Address: 192.168.1.50

IP Mask: 255.255.0.0

Host IP Address: 0.0.0.0

Gateway IP Address: 0.0.0.0

SNTP/NTP Server IP Address:

Time Zone:

HW Transmit Retry Limit: 4

SW Transmit Retry Limit: 3

TransmitPower: full

Current Transmit Output Power 19.5 dBm

SuperG :Disabled

Encryption: Enabled

Cipher selection: TKIP

Authentication Type: WPA-PSK

Default transmit key: 1

Shared Key 1, size 40, 0000000000

Access Check: Enabled

Key Entry Method: hexadecimal

Group Key Update Interval: 1800 seconds

Key Source: server

Aging Interval: 120 seconds

Telnet Access: Enabled

Telnet Timeout: 180 seconds

Minimum rate: 1 Mbps

XR Poll interval: 100 msec

XR Frame Limit: 25

XR Poll Rate String is 0.25 1 1 3 3 6 6 20

XR Fragmentation Threshold: 540

D-link Corp. Access Point wlan1 -> ping 192.168.1.39

PING 192.168.1.39: 56 data bytes

64 bytes from 192.168.1.39: icmp_seq=0. time=0. ms

64 bytes from 192.168.1.39: icmp_seq=1. time=0. ms

64 bytes from 192.168.1.39: icmp_seq=2. time=0. ms

----192.168.1.39 PING Statistics----

3 packets transmitted, 3 packets received, 0% packet loss

round-trip (ms) min/avg/max = 0/0/0

D-link Corp. Access Point wlan1 -> set syslog

sysLog set commands:

set syslog remoteip x.x.x.x

set syslog remotestate 0/1

set syslog localstate 0/1

set syslog clear all

D-link Corp. Access Point wlan1 -> version

SOFTWARE_VERSION: v2.10eu

D-link Corp. Access Point wlan1 -> rstp getstp

get wdsacl

STP Status : Enabled

Max Age : 20

Hello Time : 2

Forward Delay : 15

Priority : 32768

STP Version : RSTP

TX Hold Count : 3

Forwarding BPDU : Enabled

Bridge Current Status

Designated Root Bridge : 00-11-95-8E-CF-FC

Root Priority : 32768

Cost to Root : 0

Root Port : None

Last Topology Change : 28sec

Topology Changes Count : 3

Protocol Specification : 3

Max Age : 20

Hello Time : 2

Forward Delay : 15

Hold Time : 3

D-link Corp. Access Point wlan1 -> snmp showcomm

SNMP Community Table

 Community Name     View Name           Access Right

 ---------------- ---------------------- ------------

 public             CommunityView          read_only

 private            CommunityView          read_write

Total Entries: 2

 

D-link Corp. Access Point wlan1 -> get sntpserver

SNTP/NTP Server IP Address: 195.54.2.1

Спасибо за внимание!